Tavo Pet Car Seat Setup: Dupree II and Maeve Iso Wind

Quick answer

Install a Tavo pet car seat by locking its ISOFIX connectors to your vehicle's lower anchors, checking that the seat base is tight, and then securing your pet with the seat's internal harness. For the Dupree II, confirm the airline-compliant carry-on configuration before you fly.

Step-by-step Tavo pet car seat setup

1. Check your vehicle's lower anchors: Locate the ISOFIX lower anchor points between the backrest and seat cushion. Confirm they are visible or clearly marked and that the seating position is approved for a child or pet seat in your owner's manual. If the anchors are buried under stiff upholstery, move to a seating position where you can reach them without forcing the connector.
2. Attach the seat's ISOFIX connectors: Line up the connectors on the Tavo seat base with the vehicle anchors and push until you hear or feel both sides click. Pull the seat forward gently to confirm each connector is locked. A single click usually means only one side is engaged; reattach until both sides lock.
3. Tighten the base against the vehicle seat: Press the seat base firmly into the vehicle cushion while you take up any slack in the connector adjustment. The base should not slide more than a small amount at the anchor points. Recheck the base after every reinstall, not just the first time.
4. Route the internal harness before loading your pet: Open the seat's harness or tether system and lay it out flat so it will not twist. Place your pet inside, then fasten and adjust the harness so it sits snug against the body without pressing on the throat. A twisted strap concentrates pressure; straighten it before you tighten.
5. Set up the Dupree II for airline carry-on use: Before flying, remove the seat from the car, fold or secure the roll-down doors, and confirm the carrier is in its carry-on configuration. Check your airline's cabin pet policy separately, because airline compliance depends on the specific flight and aircraft. Do not leave the ISOFIX connectors extended in carry-on mode if they snag on the seat pocket.
6. Do a final three-point check: With your pet secured, tug the seat base at the connectors, check that the harness is flat and snug, and confirm the seat does not interfere with the vehicle seatbelt or adjacent seats. If anything shifts, start again at the connector step rather than adjusting the harness to compensate.

Product facts

• TAVO Pets Dupree II Airline Carry-on Pet Car Seat: Airline-compliant carrier that doubles as an impact-tested car seat, with magnetic roll-down doors and ISOFIX connectors. You can use one product for the flight and the drive, but you still need to complete the ISOFIX base check before every car trip.

  

• Tavo Maeve iso5X Wind Pet Car Seat: Crash-tested Maeve iso Wind Pet Car Seat with ISOFIX-style connectors and a climate-conscious design for warm-weather outings. The ISOFIX setup is the priority for car use; the airflow design is a comfort feature, not a substitute for securing the base.